Understanding your Water Test Results
Schaefer Inspection Service has 45+ years of experience in providing a wide variety of inspection services.

Your certified water test covers several categories – from bacteria and metals to dissolved gases and general water quality parameters. An elevated result doesn’t always mean something is wrong with your water source; it simply means one or more measurements fell outside recommended state or federal guidelines and treatment or further testing may be needed. The resources below explain what each result means, particularly focusing on understanding your Water Test Results, why it matters, and what steps to take next. If you have questions after reviewing them, our team is happy to help.
Your water test results, including your Water Test Results, cover several categories — bacteria, metals, dissolved gases, and general water quality parameters. This guide walks through what each measurement means, how it compares to state and federal guidelines, and how to read the report your inspector provided. Start here before reviewing any contaminant-specific fact sheet below.
The acceptable level for total coliform bacteria in drinking water is zero colonies per 100 mL — any detection means the well should not be used for drinking, cooking, or brushing teeth until it’s addressed. Bacteria typically enters through a compromised well cap, casing, or nearby contamination source. Options include shock chlorination, ultraviolet treatment, and continuous chlorination, followed by a retest to confirm the water is clear.
Lead usually enters household water from older plumbing, solder, or fixtures rather than the water source itself, and poses the greatest risk to infants, young children, and pregnant women. EPA is lowering the national lead action level from 15 to 10 parts per billion under its 2024 rule update, with full compliance required by November 2027 — a sign of how seriously this is being taken. Certified filtration, fixture replacement, and periodic flushing of standing water are common mitigation steps.
Aeration systems are the standard treatment for dissolved gases like radon and certain volatile organic compounds (VOCs) in well water. By exposing water to air (through spray, bubble, or packed-tower methods) before it reaches your taps, these systems release the gas safely rather than letting it build up indoors. A properly sized and vented system can reduce radon levels well below Connecticut’s action threshold.
Chlorination is used to eliminate bacteria and maintain ongoing protection against recontamination. This can be a one-time “shock” treatment to clear an active bacteria issue, or a continuous low-dose feed system for wells with a recurring problem. Properly treated water maintains a small chlorine residual that’s safe for household use, and retesting afterward confirms the treatment worked.
Sources: